Gallery
Printed infrared heaters can be installed anywhere and at extremely low cost. Whether in a skyscraper, in a yacht, in a modern bus or on an airplane, the heating varnish - in the form of a printed heater - operated with mains, low or high voltage, battery or solar power - can be used anywhere.
Top Therm 2 D printed underfloor heating under a laminate floor, installed in drywall construction within a few hours.
Top-Therm Basic 2-D printed and pre-wired underfloor heating installed correctly and in compliance with standards.
Top Therm Basic, 2-D printed underfloor heating. Rolls wired ready for connection and available in lengths from 2.5 m to 5 m.
Wooden house 20 m2, 3 * 4 m lanes of 80 W/m2 printed IR underfloor heating foil made by CSG IRE 550 by racket roll printing
Fully automatically coating with our heating varnish CSG-IRE-550, jumbo rolls 2500 m, 160 cm width Performance: 80 -100 W/m2.
Screen Printing. Many producer of IR Infra Red heaters are using SP Technology and our CSG-IRE 550 for 50-1500 W/m2
CSG-Heating Paint for Infra Red flat bed heaters, economic and environmentally wherever it makes sense.
CSG-IRE-550. Infra Red flat bed heaters into the whole ship, economic and environmentally wherever it makes sense.
CSG Heating paint, printed Infra Red - heaters for floor, side wall and ceiling in a buss efficent and environmentally friendly
CSG Heating Paint flat bed printed Heaters applied everywhere in a SKYSCRAPER saves hundred's of thousand of Euro for installation and after sales services.
CSG Heating Paint flat bed heaters Batterie and PV (photo voltaic System) combined means economical and ecological.